Our final installation will cover three walls, so we needed to know early whether one computer could drive more than one projector at the same time. This week we tested it with two.
What we did
We connected two projectors to one computer and made TouchDesigner treat them as one wide screen. The forest is drawn as one long image, and each projector shows its own half. Where the two images meet, we used a blend so the overlap fades softly instead of showing a hard line or a bright stripe.
What we learned
It worked. Both projectors ran smoothly from one computer, and the image continued from one projection to the next without a visible break.
This matters for the final setup. If one computer can run several projectors, everything stays in one TouchDesigner file: one forest, one set of fireflies, one rhythm. That’s simpler to build, easier to restart if something goes wrong, and cheaper than running a computer per wall.
Next steps
- Test with three projectors, one for each wall
- Check how bright the image is in a dim room
- Fine-tune the blend so the seam between projectors is invisible